1. 断开电源，确保设备处于状态。

Firstly, disconnect the power supply to ensure that the device is in a safe state.

2. 拆卸原有的油封。

2. Disassemble the original oil seal.

3. 用清洁布擦拭滚珠丝杠、螺母和轴承等零部件表面，确保表面干净无杂质。

3. Wipe the surfaces of components such as ball screws, nuts, and bearings with a cleaning cloth to ensure that the surfaces are clean and free of impurities.

4. 拆下螺母，并将滚珠丝杠从螺母中取出。

4. Remove the nut and take out the ball screw from the nut.

5. 检查滚珠丝杠、轴承等零部件是否有损坏或磨损，如有需要更换。

5. Check whether the ball screw, bearings and other components are damaged or worn, and replace them if necessary.

6. 安装新的油封，注意安装方向和密封性。

6. Install a new oil seal, paying attention to the installation direction and sealing performance.

7. 将滚珠丝杠重新安装到螺母中，并将螺母拧紧。

7. Reinstall the ball screw into the nut and tighten the nut.

8. 测试设备运转是否正常，如有异常情况需要进行调整或排除故障。

8. Test whether the equipment is operating normally, and adjust or troubleshoot any abnormal situations.

9. 检查滚珠丝杠、螺母和轴承等零部件的润滑情况，如有需要进行润滑。

9. Check the lubrication of components such as ball screws, nuts, and bearings, and lubricate them if necessary.

10. 将设备恢复正常工作状态。

10. Finally, restore the device to normal working condition.

以上的内容来自：导轨丝杠更多的精彩内容请点击我们的网站：http://www.jngongrun.com

The above content comes from: Guide screw. For more exciting content, please click on our official website: http://www.jngongrun.com